Dixon, 2741212C, 3/4in Hose ID x 3/4in Female NPTF x Push-On Hose Barb, BrassConstructionDrysealInstallationAssembly Instructions:1. Trim hose end with smooth square cut.2. Lubricate either push-on fitting, hose or both.3. Insert push-on fitting into hose until first barb is in hose.4. Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from end. Push with a steady force until end of hose is covered by yellow plastic cap.InstructionsDisassembly instructions:1. Leaving push-on fitting in place, make a 1in cut in the hose along the barbed end of the fitting. Note: Be careful not to nick barbs when cutting the hose.2. With firm grip on hose, give a sharp downward pull to release the fitting from the hose.NoteNo hose clamps or ferrules are neededSafety notesDixon push-on fittings are intended for use with Lok-On (push-on style) hose only.Caution: Push-on fittings will properly grip push-on hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap.WARNING: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm. Do not use in connection with drinking water. Wash hands after handling.